NSW Health director of health safety Richard Broome stated there was usually an increase in cases in direction of the tip of summer when the weather cooled down and using airconditioning methods began to alter. Endeavour’s principal process was supply of the Canadian Dextre robotic manipulator (fitted to the tip of the Canadarm-2 robotic arm already installed on the station) and the Japanese Kibo ELM-PS Experiment Logistics Module – Pressurized. Attributable to weather issues a touchdown at White Sands was considered; but in the long run Discovery landed safely at Kennedy Space Center, after which it was to enter a year-lengthy overhaul cycle. It landed on runway 15 at Kennedy Area Middle at 16:32 GMT. The shuttle delivered NASA lengthy-time period ISS crew member Clayton Anderson to the station; and returned Suni Williams to earth. Following profitable completion of all cargo supply and station assembly tasks, the crew returned to Endeavour on 18 August, undocking the next day at 11:56 GMT. Eyharts was dropped off at the station, Tani, already aboard the ISS, returned to Earth on Atlantis.
Payload: Atlantis F28 / S3, S4. Payload: Atlantis F29 / Columbus. Payload: Discovery F32 / Leonardo. Payload: Endeavour F20 / S5, Spacehab. The OMS-2 burn at 2313 UTC put Endeavour in a better 229 x 317 km orbit because the ET fell again to reentry around 2346 UTC. The OMS-2 circularization burn at 20:23 GMT put it into a 215 km x 233 km chase orbit. Half an earth away from jettison of external tank ET-128, a 76 m/s OMS-2 burn at 21:40 GMT put the Shuttle in its low-altitude chase lorbit. The orbiter was placed in an preliminary 58 km x 220 km orbit at principal engine shutdown, adjusted by the OMS-2 firing 38 minutes later to a 220 km x 233 km chase orbit. At SSME burnout Discovery was in a fifty eight km x 220 km x 51.6 deg preliminary burn. Discovery landed on the Kennedy Space Center at 13:14 GMT. The shuttle delivered the S3 and S4 truss segments to the starboard facet of the International Space Station. On 14 July, the station’s SSRMS robot moved the Leonardo module from the station back to the shuttle cargo bay between 13:08 and 14:50 GMT.
Four spacewalks had been conducted, primarily to repair a damaged ISS Solar Array Rotary Joint. Program: ISS. Flight: STS-131A. An MPLM would have delivered Future lab racks and a CBA to the station.. Program: ISS. Flight: STS-124 ISS EO-17. Program: ISS. Flight: STS-138A. STS-134 was to have flown ISS assembly mission ISS-16A. It would have delivered the Japanese JEM ELM PS module and SPP to the station.. Discovery docked with the ISS on the Future module at 12:Forty GMT on 25 October. Flight: Soyuz TMA-10, STS-117 ISS EO-15, STS-118. The Leonardo module contained 6956 kg of cargo, mainly devoted to permitting a future full ISS crew of six: two crew quarters racks, a Galley rack, a Waste and Hygiene Compartment rack, two Water Recovery System racks, an experiment rack, a Combustion integration rack, and miscellaneous supplies in three Resupply Stowage Racks and 6 Resupply Stowage Platforms. Program: ISS. Flight: STS-137A. Type: Manned spaceplane. Flight: Soyuz TMA-6, STS-114. STS-114 – . Call Sign: Discovery. Endeavour docked on the PMA-2 adapter on the Station at 18:02 GMT on 10 August; the hatches had been opened at 20:04. The 14036 kg of cargo broke down as follows: – Bay 1-2: Orbiter Docking System, 1800 kg – Bay 1-2: EMU 3010, 130 kg – Bay 1-2: EMU 3017, 130 kg – Bay 3: Tunnel Adapter, 112 kg – Bay 5-7: Spacehab-SM Single Module, 5480 kg: Loaded with analysis experimental gear and consumables to be left on the station.
Supplies and gear would have been delivered via an MPLM and Express Pallet in the cargo bay. Equipment and supplies would have been delivered to the station aboard an MPLM and Express Pallet within the cargo bay. It will have delivered the European Lab – Columbus (APM) to the station.. The Habitation module would have been delivered to the station.. The beforehand-delivered Japanese Logistics Module was transferred from Harmony to Kibo on 6 June at 20:04 GMT. Installation of the European Columbus module. Get-ahead set up work on the skin of the station. An MPLM and different station hardware can be delivered.. European astronaut Reiter was left behind to make up part of the EO-thirteen resident crew on the station. The station arm then linked to the P3/P4 truss to the station’s P1 truss at 07:27 on 12 September. At the Shuttle RMS robot arm linked to the enormous P3/P4 truss within the payload pay and handed it off to the Station’s robotic arm between 14:52 and 15:03 GMT the same day.